Creating a wooden wonder woman using SprutCAM X Robot

Creating a wooden wonder woman using SprutCAM X Robot | SprutCAM X20 dubna, 2024

Creating a wooden wonder woman using SprutCAM X Robot | SprutCAM XBrazil

Have you ever seen a Robot with a chainsaw and then a cutter? With SprutCAM X Robot you can completely program and simulate the work cycle including head change.
In this short video, we see that the superfluous parts of an irregular rough are cut and then only the residual part is machined.
”From a tree trunk I imported thanks to the 3D scanner it was inserted into SprutCAM X and then created the artistic figure WONDER WOMAN.
SprutCAM X is the fully integrated software (CAM+simulation) that allows you to get the most out of your Robot”
Thanks to Brazilian reseller COMAC for the video.

Sdílet tento příběh

Získejte zkušební verzi a začněte se učit online

Stáhněte si bezplatnou zkušební verzi softwaru SprutCAM X nebo SprutCAM X Robot a prozkoumejte jeho možnosti. Absolvujte online kurzy, ve kterých se naučíte používat SprutCAM X, a po jejich dokončení získáte certifikát.

Creating a wooden wonder woman using SprutCAM X Robot | SprutCAM X
Subscribe
Upozornit na
0 Comments
Inline Feedbacks
View all comments