New release SprutCAM X 16.3.5

New release SprutCAM X 16.3.5 | SprutCAM X20 prosince, 2022

What’s new

Polar interpolation new working principle.

New in polar interpolation mode

New release SprutCAM X 16.3.5 | SprutCAM X

This update fixed the ability to work in the mode when the rotary axis is positioned at an angle different then 0.

Important: some post processors may not work with this mode. For the postprocessor to work correctly, you need to contact the postprocessor developer.

New release SprutCAM X 16.3.5 | SprutCAM X

If you enable the Start at C=0 option, then the interpolation cycle will start at the axis position C=0.

New release SprutCAM X 16.3.5 | SprutCAM X

Added 3 ways to display rapid motions.

New release SprutCAM X 16.3.5 | SprutCAM X

No interpolation – rapid motions outside the cycle.

New release SprutCAM X 16.3.5 | SprutCAM X

Rapid feed – the feed will be inside the interpolation cycle, it can be set as a percentage of the working one.

New release SprutCAM X 16.3.5 | SprutCAM X

Idling feed – the feed will be inside the interpolation cycle as an idle feed

New release SprutCAM X 16.3.5 | SprutCAM X

Also added option of negative radial coordinate.

What’s fixed

  • Fixed a bug causing a black screen when opening projects with a robot
  • Fixed a bug in the 2D Contour operation
  • Fixed the occurrence of critical errors
  • Fixed a bug with the removal of residues when reordering
  • Fixed a bug with duplication of commands in the interception operation
  • Fixed a bug with filing a return
  • Fixed a bug with the selection of parameters in the inspector of turning operations
  • Fixed bug when scrolling
  • Fixed an import error from a library in MachineMaker
  • Fixed bugs with Dobot TCP in MachineMaker
  • Fixed the appearance of critical errors in MachineMaker
  • Fixed a bug with robot axis limits in MachineMaker
  • Fixed errors when working with five-axis machines in MachineMaker
  • Fixed a bug when turning on feed in the Paint operation
  • Fixed a bug with ignoring the disabled operation in the simulation
  • Fixed bug with sync points
  • Fixed bug with C-axis control in 3-axis operation
  • Fixed bugs with localization
  • Fixed a bug with the lack of notification about updating SprutCAM if there is not enough space on the hard disk
  • Fixed a bug with incorrect operation of the custom operation
  • Fixed a bug with the axial allowance in the Rough layered operation

A total of 42 changes were made to SprutCAM containing bug fixes and workflow improvements.

Conclusion

Users with active technical support have already received notifications about the release of the new release and can upgrade.

If you have any issues, please, contact our support team.

Sdílet tento příběh

Získejte zkušební verzi a začněte se učit online

Stáhněte si bezplatnou zkušební verzi softwaru SprutCAM X nebo SprutCAM X Robot a prozkoumejte jeho možnosti.
Absolvujte online kurzy, abyste se naučili pracovat se softwarem SprutCAM X, a po jejich absolvování získejte certifikát.

New release SprutCAM X 16.3.5 | SprutCAM X

Související příspěvky

Subscribe
Upozornit na
0 Comments
Inline Feedbacks
View all comments